• Digital tachometer for DC brushless motor and AC induction motor
• Speed signal input mode: Digital pulse signal, Analog voltage signal.
• Display digit：99999, five digits, Input frequency range: 0.2Hz~20kHz.
• Panel mounting dimensions：DIN.48mm X 48mm and Wiring with 11-pin terminal block.
• Features：Reduction ratio、RPM and linear speed、Number of decimal places、Display response time.
• Power supply：Single phase AC100~240V 50/60Hz.
• Can be used with an external sensor or encoder for speed detection

• Output power supply：DC24V / 1.25A, 30W rated power , 78% of efficiency.
• Can be used for signal control side or small motor driver power supply.
• Input power supply：Single phase AC100~240V 50/60Hz.
• Protection function：Surge current、Over current、Over voltage.
• All using 105°C electrolytic capacitors, with high efficiency, long life and high reliability.
• Use DIN rail(35mm) Mounting and fixing method .

• Converter for digital signal to analog voltage.
• Input signal：8-bit digital signal ( 00～FF Hex).
• Output voltage：0～4.93V (Can set 256-stage voltage output).
• Power supply：DC24V / 0.1A(Min.).
• Digitization of adjusting motor speed, can replace the manual speed adjustment of variable resistor.

• Converter between photo coupler and line driver interface.
• Enhance the resistance of noise interference with Line drive circuit.
• One module has two input ports and two outputs ports.
• Dedicated for drives or controllers with Line drive input circuit.
• Power supply: DC24V / 0.1A(Min.).

• Applied to TROY brushless motor full series, as an extension of the drive and motor connection distance.
• The longest distance can be extended by 10m.
• The inner materials made by UL 2464, which has certificated specification.
• The covering layer is made by flexible, oil-proof and rubber material.
• Use Composite multi-wire cable to shielding noise.
• There are two types : Standard CB-XXX and flex resistant CB-XXXF.
• Length specification：1m、2m、3m、5m、7m、10m.